How To Build A Stud Wall On A Concrete Slab

Dad was pretty smart he knew the concrete nails were made from hardened steel so he used a hammer with a head made of softer steel than his typical framing hammer to drive the nails in.

How to build a stud wall on a concrete slab.

Width will work with a 2 4 wall on top. Choose a length that will penetrate the concrete at least 1 inch. This prevents water from leaking under the bottom of the wall to the inside of the building. Other nails have a thick shank that sometimes has spiral ridges for improved holding power.

How to build a wall on a concrete slab. Building a nonstructural wall is simpler than it looks and even attaching it to concrete isn t a big deal. Consider a wood shed floor treated lumber joists and plywood. Your local building code may call for the wall to be anchored to the slab with threaded rods.

With simple materials and readily available tools the novice carpenter can lay out build and anchor walls on concrete slabs. Start at one end of a wall and mark the location of the first stud. The end result of the project however probably will be. Fully assemble the stud wall with a framing nail gun.

Using a plumb bob or laser level transfer those locations to the top plates. Some codes require that the sill plate be bolted to the slab while others recommend a metal strap. Wall studs are typically installed at 16 intervals when measured at their centers. Some concrete nails are the cut nail design shown in the photo with a thick flat shank and a tapering v profile.

Fasten the sill plate to the concrete slab following the recommendations of the local building code. Use a tape measure to mark out the location of the remaining studs along the wall. An exterior wall must be placed on the outside edge of the slab so the exterior siding laps down and over the edge of the slab. Be sure to wear safety goggles when hammering masonry nails into concrete.

These lintels are available in lengths up to 10 ft. If this is the case drill through the curb and into the slab with a roto hammer every few feet. Stud walls were framed and dad used spiral shanked concrete nails to attach the walls to the concrete slab.