You can use standard 2 x 4 boards and strong adhesive to create a wooden framework to which you can easily attach your paneling.
How to attach paneling to plaster walls.
While a partner holds the panel use finishing nails to attach it to the wall.
For a professional look don t hammer the nail completely in.
Clean off any dirt or debris with a soft damp cloth.
Insert 2 inch drywall screws through the drywall and into the wall studs behind the.
Cut the wood panels to the length you.
Make a mark with a pencil where the studs are.
For lighter items simply screwing into the plaster with a 1 1 4 drywall screw is usually enough to get the job done.
Join pieces in the corners with 45 degree angles.
How to install beadboard to plaster walls step 1.
Most studs are 16 inches apart so once you find one the.
Continue until all walls are covered and all moulding is attached.
Some older plaster walls have a thin strip of wood that runs around the perimeter of a room usually between 1 inch 2 5 cm to 1 foot 30 cm below the edge of the ceiling.
Use a stud finder to locate the studs in the wall.
Attach the strips to the wall with 2 inch brad nails.
Attach them with finishing nails secured to the wall studs.
Use a studfinder to locate the studs and nail into those so your panel is secure.
Locate and mark the studs on the wall using a stud finder.
Wait until the wall is completely dry.
Screws and screws with masonry anchors for heavy items are your best choice for hanging things on plaster walls without picture rail.
Set the first sheet of drywall against the wall and rest the bottom edge on top of the row of spacer boards.
The typical method of installation is to press the panel to the wall using your hand or a towel.
If your room has this you can simply drive a screw through the wood and use this to hang things.
One piece should be cut at a 15 degree angle to the front and the complementary angle on the back.
Use a nailset to set the head flush.
Then pull the panel away from the wall for about a minute to allow the glue to develop tackiness.
Press the panel back to the wall and it should hold very firmly.