Using nailpro ct3040 air pin concrete tool huge labor savings using 1 1 4 metal stucco washers 3 4 pins only 100 psi so much faster than any powder actua.
How to attach lath to concrete wall.
Prepare the wall before mounting the lath by repairing any moisture related problems.
Including cleaned and untreated concrete masonry or stucco.
How to attach wire mesh to block walls.
How to fasten lath to concrete walls step 1.
Measure and cut the wire mesh to the desired dimension.
Stucco thickness on cinder block concrete block or cmu walls add more stucco if not sure its thick duration.
Stop the metal lath 1 from finished edges.
Hold the wire mesh in the desired position.
Kirk giordano plastering inc.
It is not necessary to use expanded metal lath on fiber cement board unless required by local building codes concrete exterior or interior wall.
Draw around the outside edge of the wire mesh with plumber s.
Wire mesh is available i 28 to 36 inch widths with roll measurements from 50 to 100.
Begin at the right hand bottom corner of the wall.
Then wash the surface with.
If paper backing behind the lath is required leave the paper over hanging at the top and to the left of the sheet.
Cover the lath with a scratch coat of mortar to.
Roughen up any paint on the wall surface by sanding the wall in a series of small circles using medium grit.
Each anchor consists of an unthreaded pin set into a metal sleeve.