How To Attach Cord To Garage Door Bottom

Fasten a new garage door bottom seal to a wood garage door.

How to attach cord to garage door bottom.

Install the roller into the bottom bracket and thread the cables behind the rollers on the door. With the cable behind the roller and bracket install the bottom bracket on the garage door. Push the track into wet caulk and tight against the door bottom. This video will show you how to repair a mis aligned garage door cable.

Stand the bottom door panel on the floor in the garage doorway. Always be careful when using a sharp knife. Leave the locking pliers in place and repeat the tightening procedure on the other side. Snap a locking pliers onto the torsion tube to lock it into place while you tighten the drums.

Rotate the drum to wind the cable into the winding grooves. Now attach the cable to the bottom bracket. If your garage door cable is at an angle or l. Remove the cable from the bottom bracket and then completely remove the cable from the door.

The cables wrap around the drums as the door opens and unwind from the drums when closing. The cables attach at the bottom end to the bottom bracket that is mounted to the bottom of the bottom panel. Clamp it into place. Screw cable brackets to the door to secure the weather stripping.

Use impact driver to mount hinges to the bottom panel of garage door. Diy garage door repair and save money. Insert rollers into the brackets attached to the door. Prepare the new cable by cutting off any pieces of tape wrapped around it.