How To Attach Bathroom Sink To Wall

If not turn off the water at the main valve.

How to attach bathroom sink to wall.

Use the template that comes with the sink to mark the. Check the level again before trimming the shims with a utility knife. Drill your pilot holes for the lag screws which should be included with your wall mount sink. Remove the entire trap if necessary.

If there are large gaps at the wall or floor attach quarter round moulding along the wall or floor edge. For sinks that do not attach with a bracket ask an assistant to hold the sink at the wall so the upper holes at the rear underside of the sink. Verify the toggled wings open once you. Turn off the water supply.

Locate the large nut that connects the sink to the drain and disconnect it. Loosen the slip nut at the top of the p trap. Installing a bathroom sink in a vanity is made easier by the fact that the supply lines and the drain all remain hidden within a cabinet. Two on the rear against the wall and one on each side.

This metal or plastic nut will be located either in the wall or the floor. The pockets are not deep enough for the tabs on my sink the holes do not align etc. Install the sink if your sink includes a mounting plate you can use that for a template to drill your pilot holes. Lift the back edge of the sink onto the bracket.

Measure and mark the location of the sink on the wall again. If the cabinet has no back simply attach it to the wall so it encloses the plumbing. Drill pilot holes into the wall at the marked locations. Attach the vanity to the wall using 3 inch drywall screws.

Be sure to use a masonry. Have a small bucket ready to catch any water. Ideally i would like to mount the sink using only the two rear tabs bolted to the wall. Prepare the faucet drain and pop up.

If the holes are not completely lining up or you want a more. Remove the current sink by sliding the edge of a putty knife around the perimeter of the bathroom sink loosening any caulk that connects it. Use plumber s putty as you attach the. Slip the sink over the mounting bolts and finger tighten the mounting nuts over the washers.

Use your hands or locking pliers to unscrew the nut. Lift the sink slightly while tightening the nuts with a wrench. Follow manufacturer s directions for the size and depth of. Mount the sink to the wall.

Smear pipe dope onto the threads of the supply line compression fittings and tighten them onto the faucet supply lines. Attach the sink 1. If the cabinet has a back you ll need to measure and cut three holes for the two supply lines and the drain. The standard cast iron brackets available for vintage sinks do not seem designed for this sink s brackets.