How To Attach A Shower Door

Sink the screws into the holes from bottom to top to finish mounting the door.

How to attach a shower door.

Attach the interior handle and tighten the setscrews. Attach the door handles and any towel bars. Work on one wall jamb at a time and follow these steps. Attach the door to the jamb.

A new shower door can drastically enhance both the form function of your bathroom. Then align the holes in the wall jamb with the holes or screw anchors in the wall. Monica mangin from the weekender walks you through the steps to installi. Any suggestions on an adhesive that will work.

Make sure each screw is nice and secure but not overly tight. Place end caps on the tops of the wall channels. Install the inside door by slipping the top of the door panel into the upper inside channel then swinging the bottom of the door panel into the lower inside track. Attach the seal strip to the bottom of the door and cut it to the required length.

Align the outside door handle with the holes in the doorframe. We have a frameless glass shower door that we put a couple handles in the wrong place. Position the inside door panel against the vertical wall frame nearest the showerhead. The handles are on the inside of the shower so they.

Secure the jamb with the screws supplied by the manufacturer or the anchor. Add the door once everything is screwed and snapped into place the roller wheels go on the doors and the doors themselves are lifted into place image 1. Place one wall jamb into or over the bottom track depending on the design. We used dental floss to remove the handles from the glass but now need to reattach them.

Install the handles and the rubber stoppers image 2. The interior door goes in first and then the exterior door is installed from the bottom up. Place the glass clamp sweep into place on the door s bottom edge and secure it at the door clamp. Remove the screw on the interior lever of the door exposing the place for the magnet strip clear the space where the magnetic strip will be placed cut the magnet strip according to the size of the space apply the glue of your choice to the back of the magnet.

Stabilize the assembly by drilling a pilot hole and driving a inch screw through the outside face of the base track wherever it meets a vertical frame member.