If the door was closing too quickly move the spring to the next higher hole on the bracket.
How to adjust springs garage door.
You must release the tension on the garage door springs before attempting adjustment or replacement.
Adjust the springs on both sides of the door the same way.
Next get hold of one of the tension rods and push it into the first notch.
Take note of the notches and screws that hold the torsion spring in place.
Look for a reddish cone on the torsion spring.
Adjusting garage door extension.
Adjusting garage door springs is a common repair.
Detach the old spring from both ends and replace it with the new one and replace the pulleys as well if they are worn out.
This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track.
Adjust the spring into the proper position and make sure your garage door closes all of the way.
The other is attached to a pulley connected to the cable.
It should be placed on the left hand side of the torsion spring and placed away from the garage door s center.
Without the springs the door is very difficult to lift.
Garage door springs are used to offset the weight of the door.
When garage doors won t close all of the way or they close unevenly spring adjustment may be called for.
Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel.
To adjust your garage door s side mounted springs first open your door fully and secure it in place with a c clamp below the bottom roller.
Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension.
The cone is on the torsion spring on the left side away from the.
Retest the door.
The rod will need to be at least 18 inches long and 1 2.
How to adjust a torsion spring garage door step 1.
One end of the spring is connected to the garage door track or frame.
This can make the other parts of the garage door last a much longer time.
Use a metal rod to stick in the first notch of the cone.
How to safely adjust your garage door spring.