How To Adjust Side Springs On Overhead Garage Door

The springs extend along the shaft and work by twisting as the garage door closes by means of cables attached to each side of the lowest garage door panel.

How to adjust side springs on overhead garage door.

Release the tension on the springs by opening your garage door all the way and securing it in place with a c clamp. Adjustments to these types of spring should only be done by a professional. This video applies t. Extension springs stretch along the top track on each side.

There are two different types of spring systems for garage doors. To be able to adjust the springs the door must be in a position that release the tension on the springs. There are two torsion springs at each side of the garage door. Adjust the springs on both sides of the door the same way.

To adjust your garage door s side mounted springs first open your door fully and secure it in place with a c clamp below the bottom roller. A garage door that is not attached to the springs can fall and cause injury. See below to make sure the door is secured before you work on it. Tips for adjusting side mounted springs.

This tension makes it easier to lift the garage door from its closed position. Brace door before adjusting extension springs. Retest the door balance as you did in step 1. If it was opening too quickly move it to the next lower hole.

Failure to install the torsion springs on the correct side will cause your door to function improperly and could result in serious injury. If the door was closing too quickly move the spring to the next higher hole on the bracket. The torsion spring helps the garage door open and close easily. Black winding cone torsion springs are used on the right side of the door and red winding cone torsion springs are used on the left side of the door when viewing the door from the inside looking out.

Then disconnect any existing safety cables and remove them away from the door springs. These types of springs can be adjusted by the. The springs are located at the top inside part of the garage door. Torsion springs are mounted directly above the door and need to be wound with special tools.

Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension. For extension springs this is in the up position.