Attach it with screws.
How to adjust hanging sliding doors.
Loosen the screws holding the sliding wheels to the top of the door with a screwdriver until you can slide the attachment plates freely.
Many times the door rollers will come off the upper track.
Make sure to adjust the wheel assemblies on the doors verifying that 1 inch of the roller is showing.
On my door the holes had plastic plugs in them.
Use nails or screws to install the wood strip and slide the bottom track over the wood strip.
Both doors should operate smoothly on the upper track.
I used a steak knife to pry the plugs loose.
Do the same on the other door.
Turning this screw raises or lowers the roller.
Determine the need for adjustment.
Give the screw a clockwise turn and test to see whether the door slides easier.
Turning the screw clockwise will cause the door to lift while turning the screw anti clockwise will cause the door to lower.
There are holes on your sliding glass door that conceal the adjusting screws to these rollers.
If the door moves haltingly or grinds on the lower rail as it is being opened or.
Pick up one door panel with the outside facing you tilt the top back and slip it into the top track.
If the door becomes even harder to open turn the screw in the opposite direction.
Adjust the plates so that the metal at the top of the plate is seated against the top of the glass.
Slide the door back and forth.
To fix it you ll have to work from inside the closet so get a flashlight and screwdrivers.
Inside a standard sliding glass door there are adjustable rollers that help it slide back and forth on the track.
To adjust a door that swings open or closed on its own it is probably because the door lining frame is out of plumb.
Usually the mounting bracket screws have loosened up making the door sag and rub against the carpet or floor.
Move the door up or.
Most sliding doors have a mechanism called an adjusting screw located at the bottom of the door ends.
Look at the rollers.
If you need to adjust the doors to make them hang evenly loosen the screws that hold the rollers to the door slightly.
While you are at it it is also a good time to give the sliding door track a good clean and get rid of any gunk that may have accumulated.
Hold it against the jamb while you adjust the brackets as shown.