It is very important to keep the rod in place as this could be what is potentially dangerous.
How to adjust garage door torsion bar.
How to adjust a torsion spring garage door step 1.
Look for a reddish cone on the torsion spring.
Refer to figure tor 1 for the configuration of 2 x 6 wood jambs.
Work the wrench in a circle turning it the same number of times that you turned the bolt on the other side of the vehicle.
Torsion spring installation and adjustment step 1 preparing the door frame.
Diy garage door repair and save money.
This video will show you how to repair a mis aligned garage door cable.
If you remove the rod while loosening the screws of the torsion spring it could be adjusted and hit.
Arrange the socket on a ratchet wrench on top of the opposite bolt and begin rotating the tool.
Adjust the torsion bar bolt on the other side of the vehicle in the same way.
Step 2 assemble the torsion springs to the spring tube.
The cone is on the torsion spring on the left side away from the.
Step 3 attach.
Tighten the adjuster three full turns clockwise to add tension if the door closed and did not remain open halfway.
Loosen the adjuster three turns counterclockwise if the door raised without.
The wood must be.
Use a metal rod to stick in the first notch of the cone.
The rod will need to be at least 18 inches long and 1 2.