Check the top of the hinge to see if it has a screw which protects.
How to adjust fire door hinges.
When this happens the top corner of the door catches on the door frame and prevents the door from closing properly.
Step 1 examine the top corner of your door to see if it s catching on the frame.
Test the door close rate.
This hole is normally located either at the top or the bottom of the hinge s housing.
Changing tension with a hex wrench 1.
Adjusting a spring loaded hinge must be done with the door closed.
Kitchen and bathroom cabinet door hinges are really easy to adjust.
Over time the hinges on a door can loosen and cause the door to sag downward.
Place the locking pin nearer to the door and release the spring pressure.
Insert a hex wrench into the.
I ll bet that you never knew you could adjust a self closing door hing.
With a small screwdriver you can adjust the door left and right back and forth and up and down as well.
Unscrew the locking screws from the top hinge.
Tighten or loosen in small steps.
If the top corner of your door is catching on the frame you ll need to adjust the hinges 1 x research source another step 2 tighten the screws on the door hinges with a screwdriver.
Find the hole beside the locking pin on the hinge s spring which is usually either at the top of bottom of the hinge s housing.
Close the door completely.
Tightening the door.
Remove the pin with a pliers.
Remove the locking pin by rotating the adjustment in the direction of the jamb.
If your hinge has a tension pin inserted into the side of the hinge you need to pull the pin from the hinge with needle nose.
If it does not fully close the hinge will need tightening.
Place the hex wrench into the socket at the top of the spring hinge and turn in either direction to release tension on the pin.
Stand on the side of the door with the hinges and shut the door until it latches.
Rotate the locking pin to remove and replace the pin one hole further away from the door.
Rotate the wrench until the next hole comes into view and install the pin.