How To Adjust A Garage Door With 2 Large Sprins

Your door will have either one or two torsion springs.

How to adjust a garage door with 2 large sprins.

Adjust the spring into the proper position and make sure your garage door closes all of the way. If your garage door slips down below the header after you have opened it you garage door springs need to be adjusted. Once the spring is free of tension remove from its track hanger. A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem.

The springs are located at the top inside part of the garage door. There are two different types of spring systems for garage doors. The other is attached to a pulley connected to the cable. Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel.

Each torsion spring consists of spring coils stationary cone and a winding cone fig. Adjust the springs on both sides of the door the same way. Detach the old spring from both ends and replace it with the new one and replace the pulleys as well if they are worn out. The spring coils are color coded depending on the spring size and the.

Torsion springs are mounted directly above the door and need to be wound with special tools. You must release the tension on the garage door springs before attempting adjustment or replacement. The torsion spring helps the garage door open and close easily. The torsion springs and all the related apparatus are situated at the top of a garage door.

If it was opening too quickly move it to the next lower hole. This video applies t. If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments. Garage door springs offset the weight of the door and allow it to open and close with ease.

Please help support my channel so i can continue to make and provide the best possible video content for you to enjoy http www solwayplumbers co uk donate. There are two torsion springs at each side of the garage door. This enables the opening and closing of the garage door. This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track.

The whole garage door apparatus is very economically and smartly designed. If the door was closing too quickly move the spring to the next higher hole on the bracket. Retest the door balance as you did in step 1. The torsion shaft powered by the spring lifts drums that easily winds cables connected with the doors at the bottom.