Honda Door Lock Actuator Screws Stuck

If you are having problems with your door locks this is the video for you make sure to watch until then.

Honda door lock actuator screws stuck.

Observe the plastic tab above and beneath this screw. There is many helpful tips and tricks to aid you in. Take the inside door release lever panel off and push the lever rod all the way to the rear. In some cars the door lock actuator is positioned below the latch.

The lock actuator is behind this screw. Remove the single screw in the middle of the gold plate taking care to note the position orientation of the small locking lever. Remove this screw and unhook the tabs holding the black plastic housing for the actuator. Unclip and remove the inside door handle rod can t remember if i did this before or after unscrewing the locking mechanism.

The latch assembly gets corroded and when the pull lever cannot return fully to the rest position the latch assembly will not operate. 2007 honda cr v door lock actuator repair. Install the lock subassembly onto the new door lock actuator using the new screws from the kit p n 72116 swa a01 and p n 72116 swa 003. Car door lock actuators are designed to lock and unlock a door without the effort of pulling on a cable and rod.

Just unhook and slide through the holes on the metal. Make sure the open link tab fits into the open link slot. Unclip the broken actuator from the locking assembly. Using a screwdriver test that the locking mechanism works by locking the latch then checking if the door latch releases using the outer handle lever.